MISCELLANEOUS

5 items

BODY BRUSH

An excellent brush for cleaning the outside of instrument bodies. Great for getting around posts,...

An excellent brush for cleaning the outside of instrument bodies. Great for getting around posts, springs, tone holes, etc. The thick fill is made from soft yet firm pure boar bristles that hold soap and water well.Durable plastic handle and safe, non-marring nylon ferrule. Overall length: 12" (30.5cm) Brush Fill diameter: 1" (25.4mm) Brush Fill length: 2" (50.8mm)

$7.95

Product SKU: 3531

FLUTE/PICCOLO TUNING ROD

At last, a tuning rod for flute and piccolo headjoints that is also designed for removing and ins...

At last, a tuning rod for flute and piccolo headjoints that is also designed for removing and inserting tuning corks. The #2424Flute/Piccolo Cork & Tuning Rod is machined from #6061 T6 aluminum, and hasa sturdy 3/8" diameter and 10" length with a nicely polished finish.Each end of the rod is marked to designate instrument and has an accurately cut,easy to read, cork positioning mark. For driving out old stuck corks, one end of the rod is drilled with a hole largeand deep enough to fit ove...

$16.50

Product SKU: 2424

DUCKBILL PLIERS - CURVED JAW

These duckbill pliers offer broad 5/8" (16mm) wide curved jaws to provide good support and contro...

These duckbill pliers offer broad 5/8" (16mm) wide curved jaws to provide good support and control for key straightening and adjustments. Contoured handle with cushioned grips.Dimensions: Jaw width: 0.625" (16mm) Jaw depth: 1.5" (38mm) Overall length: 6.5" (168mm)

$26.85

Product SKU: 6763

STEEL BENCH BLOCK

Made from high quality tool steel, these precisionbench blocks are ground flat, polished, and cas...

Made from high quality tool steel, these precisionbench blocks are ground flat, polished, and case-hardened. A necessity on anywoodwind bench for flattening spring ends, leveling key cups, etc.Dimensions: 0.750" (19.0mm) thick 2.500" (63.5mm) square

$41.25

Product SKU: 3550

*DISCONTINUED*

PUNCH & THREAD CUTTING TOOL

Our Punch and Thread Cutting Tool is an excellentaddition to any woodwind bench. Precision design...

Our Punch and Thread Cutting Tool is an excellentaddition to any woodwind bench. Precision designed and constructed to perform the followingtasks: key pin removal and installation thread cutting hinge rods flattening ends of needle springs Comes complete with: Main tool frame Drill chuck - open bore - capacity 0.015" - 0.25" (0.4mm - 6.5mm) 3 Key pin punches 3 Key hinge bases - 2 'V' blocks and 1 lead block Hammer punch & Anvil base - tool steel for ...

$270.00

Product SKU: 2780
×
Welcome Newcomer